M95080 datasheet(13/45 Pages) STMICROELECTRONICS

13 / 45 page

M95160, M95080

Operating features

13/45

4.1.4

Power-down

During power-down (continuous decrease of VCC below the minimum VCC operating

voltage), the device must be:

●

deselected (Chip Select S should be allowed to follow the voltage applied on VCC)

●

in Standby Power mode (there should not be any internal Write cycle in progress).

4.2

Active Power and Standby Power modes

When Chip Select (S) is low, the device is selected, and in the Active Power mode. The

device consumes ICC, as specified in Table 13. to Table 18.

When Chip Select (S) is high, the device is deselected. If a Write cycle is not currently in

progress, the device then goes into the Standby Power mode, and the device consumption

drops to ICC1.

4.3

Hold condition

The Hold (HOLD) signal is used to pause any serial communications with the device without

resetting the clocking sequence.

During the Hold condition, the Serial Data Output (Q) is high impedance, and Serial Data

Input (D) and Serial Clock (C) are Don’t Care.

To enter the Hold condition, the device must be selected, with Chip Select (S) low.

Normally, the device is kept selected, for the whole duration of the Hold condition.

Deselecting the device while it is in the Hold condition, has the effect of resetting the state of

the device, and this mechanism can be used if it is required to reset any processes that had

been in progress.

The Hold condition starts when the Hold (HOLD) signal is driven low at the same time as

Serial Clock (C) already being low.

The Hold condition ends when the Hold (HOLD) signal is driven high at the same time as

Serial Clock (C) already being low.

4.4

Status Register

Figure 6. shows the position of the Status Register in the control logic of the device. The

Status Register contains a number of status and control bits that can be read or set (as

appropriate) by specific instructions. See Section 6.3: Read Status Register (RDSR) for a

detailed description of the Status Register bits

M95080 bảng dữ liệu(PDF) 13 Page - STMicroelectronics