STA529 datasheet(18/58 Pages) STMICROELECTRONICS

18 / 58 page

PLL

STA529

18/58

5.1

Functional description

Phase/frequency detector

The phase/frequency detector (PFD) compares the phase difference between the

corresponding rising edges of INFIN and FBCLK, (clock output from the loop frequency

divider) by generating voltage pulses with widths proportional to the input phase error.

Charge pump and loop filter

This block converts the voltage pulses from the phase/frequency detector to current pulses

which charge the loop filter and generate the control voltage for the voltage-controlled

oscillator. The loop filter is placed external to the PLL on pin FILT.

Voltage controlled oscillator

The voltage controlled oscillator (VCO) is the oscillator inside the PLL. It produces a

frequency output (FVCO) proportional to the input control voltage.

Input frequency divider

This frequency divider divides the PLL input clock CLKIN by a factor called the input division

factor (IDF) to generate the PFD input frequency INFIN.

Loop frequency divider

This frequency divider is present within the PLL for dividing FVCO by a factor called the loop

division factor (LDF). The output of this block is the FBCLK.

Output frequency divider

The PLL output PHI is generated by dividing the FVCO by the output division factor (ODF).

The divider that divides the FVCO to generate the clock to the core is called the output

frequency divider. In the STA529, the ODF is fixed to be divisible by 2 and cannot be

configured.

Lock-detect circuit

The output of this block (the LOCKP signal) is asserted high when the PLL enters the state

of COARSE LOCK in which the output frequency is within +/-10% (approximately) of the

desired frequency. The LOCKP signal is refreshed every 32 cycles of the INFIN. The

generated value is based on the result of comparing the number of FBCLK cycles in a

window of 14 INFIN cycles. The different cases generated after comparison are as follows.

●

If LOCKP is already at 0, then in the next refresh cycle LOCKP goes to 1 if the number

of FBCLK cycles in the 14-cycle INFIN window is 13, 14, or 15. Otherwise LOCKP

stays at 0.

●

If LOCKP is already at 1, then in the next refresh cycle LOCKP goes to 0 if the number

of FBCLK cycles in the 25-cycle INFIN window is less than 11 or higher than 17,

otherwise LOCKP stays at 1.

●

If LOCKP is already at 1 and CLKIN is lost (no longer present on the input pin), LOCKP

stays at 1. In this case, the PLL is unlocked.

STA529 bảng dữ liệu(PDF) 18 Page - STMicroelectronics

STA529 bảng dữ liệu(HTML) 18 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

bảng dữ liệu tải về

Link URL