AX6108 datasheet(21/31 Pages) ETC2

21 / 31 page

Display Control Instructions

Outline

Table 2 shows the instructions. Read/write (R/W) signal, data/instruction (D/I) signal, and data bus

signals (DB0 to DB7) are also called instructions because the internal operation depends on the signals

from the MPU.

These explanations are detailed in the following pages. Generally, there are following three kinds of

instructions :

1. Instruction to set addresses in the internal RAM.

2. Instruction to transfer data from/to the internal RAM.

3. Other instructions.

In general use, the second type of instruction is used most frequently. Since Y address of the internal

RAM is increased by 1 automatically after writing (reading) data, the program can be shortened.

During the execution of an instruction, the system cannot accept instructions other than status read

instruction. Send instructions from MPU after making sure that the busy flag is 0, which is proof that

an instruction is not being excuted.

------------------------------------------------------------------------------------------------------------------------

AX6108 Dot Matrix Liquid Crystal Graphic Display Column Driver

------------------------------------------------------------------------------------------------------------------------

¸ à

µ Ø

¹ q¤ lª Ñ

¥ ÷

¦ ³

- -

¤ ½

¥ q

ASLIC MICROELECTRONICS CORP.

Page 21

SALES BY TITRON INTERNATIONAL CORP.

AX6108 bảng dữ liệu(PDF) 21 Page - List of Unclassifed Manufacturers