WM8580 datasheet(21/103 Pages) WOLFSON

tên linh kiện	WM8580

Giải thích chi tiết về linh kiện	Multichannel CODEC with S/PDIF Transceiver

PDF	103 Pages

Scroll/Zoom	100%

nhà sản xuất	WOLFSON [Wolfson Microelectronics plc]

Trang chủ	http://www.wolfsonmicro.com

Logo

21 / 103 page

Production Data

WM8580

PD Rev 4.5 February 2008

The WM8580 allows readback of certain registers in 2-wire mode, with data output on the SDO pin.

As in 3-wire mode, there are two methods of reading back data: continuous and non-continuous

readback. Continuous readback is set by writing to the Readback Control register (see Table 9) to

set READEN and CONTREAD to 1, and to set the READMUX bits to select the register to be read

back. The status of this register can then be readback using the protocol shown in Figure 10.

Figure 10 2-Wire Continuous Readback

If CONTREAD is set to zero, the user can read back directly from the register by writing to the

Figure 11.

Figure 11 2-Wire Non-Continuous Readback

SOFTWARE REGISTER RESET

Writing to register R53 will cause a register reset, resetting all register bits to their default values.

Table 11 Software Reset

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R53

RESET

35h

8:0

RESET

n/a

Writing any data value to this register

will apply a reset to the device

registers.

WM8580 bảng dữ liệu(PDF) 21 Page - Wolfson Microelectronics plc