| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
IMX91LP4EVK bảng dữ liệu(PDF) 7 Page - NXP Semiconductors |
|
|
|||||||||||||||||||||||||||||
IMX91LP4EVK bảng dữ liệu(HTML) 7 Page - NXP Semiconductors |
|
7 / 12 page ![]() 1 Confirmboot switches The boot switches should be set to boot from “eMMC”, SW1301[4-1] (Figure 1) are used for boot, See table below: BOOT Device SW1301[4-1] eMMC/uSDHC1 0000 Note: 1 = ON 0 = OFF 2 ConnectUSB debug cable Connect the UART cable into the port JP1401 (Figure 1). Connect the other end of the cable to a PC acting as a host terminal. UART connections will appear on the PC, The third port will be used as A55 core system debugging. Open the terminal window (i.e., Hyper Terminal or Tera Term), choose the right COM port number and apply the following configuration. • Baud rate: 115200 bps • Data bits: 8 • Parity: None • Stop bits: 1 3 Connectparallel panel display Plug the parallel LCD panel (TM050RDH03-41) into J1001 2x20 PIN EXPI. Change DTB to “imx91-11x11-evk-tianma- wvga-panel.dtb” in u-boot phase. 4Connect mouse Connect the mouse to the USB2 C port connector J302 through USB C OTG cable. Setting up the system The following will describe how to run the pre-loaded Linux image on the IMX91LP4EVK (i.MX 91). 7 Quick Start Guide i.MX 91 EVK |
|
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |