17

©2022 Renesas Electronics Corporation

R31DS0067EU0401 February 10, 2022

XP Datasheet

Package Outline Drawings

The package outline drawings are located at the end of this document and are accessible from the Renesas website. The package

information is the most current data available and is subject to change without revision of this document.

7.0 × 5.0 mm, 8-CLCC (JD8D1) package

5.0 × 3.2 mm, CLCC-8 (JX8D1) package

3.2 × 2.5 mm, 8-COL (JSW8D1) package

Marking Diagrams

Figure 16. Marking Configuration for the 7.0 × 5.0 mm and 5.0 × 3.2 mm Packages

Figure 17. Marking Configuration for the 3.2 × 2.5 mm Package

XPxxxx

ABC-YW

$PF**

▪ Line 1 denotes the truncated part number (e.g., “xxxx” is L726, P516).

▪ Line 2 indicates the following:

• “ABC” denotes the truncated first three digits of the frequency code (e.g., 156).

• “-YW” denotes the last digit of the year and week when the part was assembled.

▪ Line 3 indicates the following:

• “$” denotes the mark location.

• “PF” is where “P” denotes the package coding number and “F” denotes the frequency coding number.

• “**” denotes the sequential lot number.

▪ Line 1 indicates the following:

• “ABC” denotes the truncated first three digits of the frequency code (e.g., 156).

• “-YW” denotes the last digit of the year and week when the part was assembled.

▪ Line 2 indicates the following:

• “$” denotes the mark location.

• “PF” is where “P” denotes the package coding number and “F” denotes the frequency coding number.

• “**” denotes the sequential lot number.

ABC-YW

$PF**