E5CC-RX3D5M-000 datasheet(12/138 Pages) OMRON

12 / 138 page

E5GC

Terminal Block Appearance

Wires:AWG24 to AWG18 (equal to a cross-sectional area of 0.21 to 0.82 mm2) braided or solid wires

Note: Refer to Precautions When Wiring E5GC (Controllers with Screwless Clamp Terminal Blocks) on page 132 for information on wiring

Controllers with screwless clamp terminal blocks.

Nomenclature

Controllers with Screw Terminal Blocks

• Terminal type: Forked or round crimped terminals

• Tightening torque for all terminals: 0.43 to 0.58 N·m

5.8 mm max.

E5GC-

Controllers with Screw Terminal Blocks (M3 Screws)

0.8 to 1.4 mm

8 to 12 mm

Controllers with Screwless Clamp Terminals Blocks

• Wire stripping length: 8 to 12 mm

• Ferrules: 8 to 12 mm

E5GC-

Controllers with Screwless Clamp Terminal Blocks

Left-panel

Setup Tool

port

Left Side View of the E5GC

Bottom View of E5GC

Bottom-panel Setup

Tool port

Front panel

Use the

U D Keys to set the parameter.

PV or specified parameter

SP or specified parameter value

Use the

M Key to change

to another parameter.

No.2 display

Use

S Key to change the

digit (default setting).

No. 1 display

Operation indicators

Temperature unit

Press

O Key once to go to Adjustment Level.

Press

O Key for at least 3 seconds

to go to the Initial Setting Level.

E5GC

E5CC-RX3D5M-000 bảng dữ liệu(PDF) 12 Page - Omron Electronics LLC

E5CC-RX3D5M-000 bảng dữ liệu(HTML) 12 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL