G-319

A22E

Installing/Removing the Switch Blocks

Installing the Switch Blocks

Hook the small protrusion on the Mounting Latch into the groove on

the other side of the lever, then push up the Switch Block in the direc-

tion indicated by the arrow in the figure below.

Removing the Switch Blocks

Insert a screwdriver between the Mounting Latch and the Switch

Block, then push down the screwdriver in the direction indicated by

the arrow in the following figure.

Wiring

Wiring Round Crimp Terminals

Loosen the terminal screw from the Switch Unit until it completely

comes off the groove, insert a screwdriver as shown in the following

figure, then push up the washer in the direction indicated by the

arrow to temporarily secure it. Now, a round crimp terminal can be

connected. After inserting the terminal, tighten the screws to com-

plete wiring.

Lever

Switch Block

Protrusion

Mounting

Latch

Use either of the following screwdrivers.

Screwdriver

3 to 6 mm

3 to 6 mm

Flat-head

screwdriver

Phillips

screwdriver

Screw

Washer

Screwdriver