6015607 datasheet(13/44 Pages) CLARKE

13 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTION

IMPORTANT: This product requires a 64A power supply which may make it

unsuitable for some users.

The welder MUST be connected to a 230 Volt/1 phase 50Hz supply through a suitably

rated isolator switch. Before switching on, make sure that the voltage of your

electricity supply is correct. Connecting it to any other power source may cause

damage..

If the colours of the wires in the power cable of this product do not correspond with

the markings on the terminals of your plug, proceed as follows.

• The Blue wire must be connected to the terminal which is marked N or

Neutral.

• The Brown wire must be connected to the terminal which is marked L or Live.

• The Yellow wire must be connected to the terminal which is marked E or

Earth.

If in any doubt, consult a qualified electrician. DO NOT attempt any work yourself.

WARNING! READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO A

POWER SUPPLY. THE INSTALLATION OF THIS APPLIANCE

SHOULD BE CARRIED OUT BY A COMPETENT ELECTRICIAN AND

BE IN ACCORDANCE WITH CURRENT IEE WIRING

REGULATIONS (BS4343).

WARNING: THE WIRES IN THE POWER CABLE OF THIS

PRODUCT ARE COLOURED IN ACCORDANCE WITH THE

FOLLOWING CODE:

BLUE = NEUTRAL

BROWN = LIVE YELLOW = EARTH

6015607 bảng dữ liệu(PDF) 13 Page - Clarke International