6

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

19. ALWAYS wear the powered air purifying respirator when entering a

contaminated area. DO NOT remove the respirator until outside the

contaminated area.

20. Dangerous contaminants may not smell or be visible. Leave the area

immediately if you notice the following:

• Breathing becomes difficult.

• You experience dizziness, impaired vision, or eye nose, or mouth

irritation.

• The powered air purifying respirator alarm sounds.

• The equipment is damaged.

• Air flow decreases or stops.

• If you think the equipment is not supplying adequate protection.

21. DO NOT remove the equipment until you are in a safe area.

22. DO NOT repair, modify, or disassemble the powered air purifying respirator

or use with parts or accessories not supplied by the manufacturer. Use only

those components that are part of the approved assembly.

23. Replace damaged or clogged filters. DO NOT wash or reuse filters. DO NOT

clean filters by tapping or with compressed air or filter elements may be

damaged. Dispose of used filter elements according to local requirements.

24. The powered air purifying respirator must be used with the helmet, hood,

and filters recommended by the manufacturer to provide a respirator

system. See the label on the blower for information on the required

equipment.

25. DO NOT use the powered air purifying respirator belt or shoulder straps (if

equipped) as a safety harness.

FURTHER IMPORTANT WARNINGS

1. This product helps protect against certain airborne contaminants

2. DO NOT use in flammable or explosive atmospheres. Doing so may result in

serious injury or death.

3. ALWAYS correctly use and maintain the filter assembly. Failure to do so may

reduce respirator performance, over-expose you to contaminants, and

may result in sickness or death.

a. Inspect filter and bottom gasket before first installation of a filter, replace

if damaged.

b. ALWAYS properly install the filter into the blower unit

c. Keep the bottom sealing gasket clean.