Mode Thickness expander

#For frequencies from 7.68 to 8.0MHz ACT CC MG series is recommended as the characteristics are better.

Tel :

0044 (0)118 979 1238

Fax :

0044 (0)118 979 1283

email :

info@actcrystals.com

Please note that all parameters can not necessarily be specified in the same device

C1 & C2

±0.4%

(-20 ~ +80°C)

ZTTCV MT

Customer to specify : Frequency, Package Type and Size

In line with our ongoing policy of product evolvement and improvement, the above specification may be subject to change without notice

ISO9001:2000 Registered

Capacitors (pF)

Internal

The ACT ZTTCV families comprise of a range of surface mount, ceramic resonators

("chip" type) in both two and three pad format. Three pad versions have built in

capacitors. This family offers a cost effective solution for applications requiring good

stability over a wide temperature range, together with accuracy.

Aging over

Stability over

Ten Year (%)

Number

Range (MHz)

temp. range

Frequency

Mode Thickness expander 3rd O/T

Specification may vary from above please enquire

Accuracy %

± 0.5

50.01-60

(-20 ~ +80 °C)

7.68-13#

3 The Business Centre, Molly Millars Lane, Wokingham, Berkshire, RG41 2EY, UK

http://www.actcrystals.com

For quotations or further information please contact us at:

ZTTCV SMD Resonators

Specification

Part Type/

Frequency

Test IC

22 internal

1/6TC4069UBPx2

± 0.3

ZTTCV MX

13.01-50

74HCU04 x 2

± 0.4%

± 0.3

22 Internal

± 0.5

Important note when using Ceramic resonators with micro controllers:

Some resonator parameters vary considerably with frequency and physical construction/size . These differences are

too great to be able to be practically shown in a data sheet.

However, these parameters can be critical when the resonators are used with micro controllers. Even if two different

resonators appear to have the same specification the typical values of these critical parameters can be considerably

different. When enquiring about resonators for use with micro controllers it is important to supply the make and part

number of the IC to be used and/or the list of recommended resonators, if this is given.

Issue: 7 C1r

Date: 10/10/05