4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ASSEMBLY ADVICE

1. Assemble on a strong, level surface. Avoid assembly on a domestic carpet.

2. Use a cloth or softwood block to protect the surface finish of the product

when using a mallet. Strike the flat surface of each beam to prevent

damage to the beam.

3. Always ensure that the rivets sit at the bottom of the keyhole slots.

4. It is recommended that the assembly should be done by two persons.

5. The shelving unit is not recommended for outdoor use.

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED

Rubber mallet or hammer

Protective cloth/wood block

The tabs of the beams will often enter

the slots fully using just firm hand

pressure but if they are too tight, you

may require a rubber mallet to assist.

If so, always use a cloth to protect

the product paint finish.

Tap gently with the mallet to drive the

tabs of the beams fully into the slots in

the corner post. Always strike the

edge close to the post.

1. Use the short beams (D) to

connect the front and rear corner

posts together as in Fig 1.

NOTE: The edge with the wider

flange should be installed

uppermost to support the

shelf.

•

Repeat this again to create the

other end assembly, making sure

that the corresponding beams

are at the same height as in Fig 2.