9

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

STORAGE

ALWAYS get assistance when folding the crane into its storage configuration.

1. When storing, the stabiliser must be locked in the down position. You may

need to tilt the crane back slightly to position the stabiliser correctly

.

2. With an assistant supporting the crane, pull out the ‘R’ clip (27), which

secures the front leg lock pin, then pull out the lock pin.

3. Raise the leg up to the storage position.

4. Replace the leg lock pin (26), through the hole

provided in the frame so that the leg is locked in

the up position,

5. Replace the ‘R’ clip to secure the locking pin.

6. The pump handle (19) is housed in a bracket on

the side of the main support post (20).

7. Once the crane is folded use extreme care when

moving it to the storage location.

STORAGE WARNINGS

1. The crane MUST be firmly secured to a wall or

fixed location when not in use.

2. Use a strong strap or chain or suitable restraint to

prevent any accidental movement.

3. Test that the crane is firmly secured before leaving it in its storage location.

Alternatively you can lay the crane down and store it flat.

Always secure the jib in its lowest position.

During use

The stabiliser should be placed in the

up position and locked in place

using the heavy duty R Clip (30)

During storage

The stabiliser should be placed in the

down position and locked in place

using the heavy duty R Clip (30)