8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

NOTE: This device will not jumpstart a vehicle if the battery is very low.

NOTE: Ensure that the jumpstarter is at least 80% charged before you attempt

to jumpstart.

CONNECTING THE JUMPER CABLE TO THE JUMPSTARTER

1. Lift the rubber plug and insert the

jumpstarter cable connector into the vehicle

starter cable port.

• The LEDs on the smart cable will indicate

the units internal battery voltage status

and the display symbols will flash.

CONNECTING THE START LEADS TO THE VEHICLE BATTERY

ALWAYS carry out the following preliminary checks before connecting the jump-start

to the car battery:

• Switch off the vehicle ignition and all ancillary equipment (lighting, radio etc.)

• Ensure the vehicle battery is rated at 12V and not damaged in any way.

• Ensure the area is well ventilated.

• Make sure that the battery terminals are clean and the clamps are firm and

secure.

• If fitted, remove any vehicle battery filler plugs and check the electrolyte

level. If necessary, top up with distilled water.

• Verify the jump starter is fully charged and recharge if needed.

1. Connect the red positive (+) clamp to the positive (+) battery terminal first. Take

care the clamps DO NOT touch any moving parts or fuel lines.

2. Connect the black clamp to the earthed battery terminal, (this is usually the

negative (-ve) terminal and coloured BLACK) or to a suitable earthing point on the

vehicle chassis ensuring the connections are firm and secure. Consult the vehicle

manual for correct connection position.

CAUTION: TO AVOID DAMAGE TO THE VEHICLE'S ELECTRICAL SYSTEM, DO

NOT USE THE JUMP STARTER ON A VEHICLE THAT HAS NO BATTERY

INSTALLED.

CAUTION: DO NOT TOUCH POSTIVE AND NEGATIVE BATTERY CLAMPS

TOGETHER.