8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

CHARGING USING THE 12V ADAPTOR

1. Plug the jack plug into the charging socket at the front of the unit, then into

the cigar lighter socket on the vehicle and start the engine. The RED/

YELLOW/GREEN CHARGING lights on the jump-start will indicate that

charging is in progress.

2. Continue to charge until the GREEN LED illuminates.

NOTE: We recommend that you use this system only when necessary, as

prolonged use will reduce the life expectancy of the battery, due

to the fact that this method can only charge the battery to

approx. 50% of its capacity.

NOTE: For maximum battery life, we strongly recommend that you

maintain the battery in a fully charged state at all times.

NOTE: If charging does not take place, check the green LED on the

adapter. Ensure all connections are clean and free of grease etc.

BATTERY TEST FUNCTION

Before using the jumpstarter, press the

test button and the LED display will

indicate the battery status.

• If the voltage is <17V, the green

LED will flash with an alarm on.

• If the voltage is 12.2 - 17V the

green LED will be constantly on,

showing the battery is fully

charged.

• If the voltage is <12.2V, the

yellow LED will be on, showing that the battery requires charging.

• If the voltage is between 10 & 12 V, the Red LED will be on, indicating

that the battery requires charging badly before it can be used.

• If the voltage is from 8-10 volts, the Red LED will flash with an alarm

on. The battery requires immediate charging.

• If the voltage is less than 8V the unit will shut off automatically.