5

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

Your ventilation fan should be

supplied with the following parts:

• 4 x castors (2 with brakes)

• 16 bolts, 16 nuts, 16 spring

washers and 32 flat washers.

Bolt the castor assemblies to the

frame as shown using the fastenings

supplied. Install the castors with

brakes at one end of the frame.

This ventilator can be used with

Clarke 20” diameter retractable

ducting available in 5 metre lengths

sold separately as follows:

Orange (3230243) or Yellow (3230286)

1. Before use, attach the ducting to

the discharge end of the

ventilator as shown, secured with

the tie cord provided.

2. Place the ventilator in a level

position on a flat surface and at a safe distance from flammable materials.

3. Set the angle of tilt as required using the hand knob shown.

4. Connect the ventilator to a suitable power outlet. The ventilator is

operated by the ON/OFF switch.

5. Always apply the brakes before operating the ventilator.

MAINTENANCE

Clean the ventilator with a soft damp cloth, Do not use solvents or abrasives.

If used in spaces with high dust content, clean the guards and fan blades by

vacuuming or wiping. Remove the end guard to gain access to the blades by

removing the four securing screws.

REPLACE GUARD BEFORE RE-CONNECTING TO POWER SUPPLY.

WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE

PERFORMING ANY CLEANING OR MAINTENANCE TASKS. REPAIRS

SHOULD BE CARRIED OUT BY THE CLARKE SERVICE DEPARTMENT.