6

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SPECIFICATION

AIR SUPPLY

For best results, the air supply to the spray gun must be clean and dry, with no

oil or water contamination. Follow the air compressor manufacturer’s

guidelines on installation and operation to ensure that your air supply is as

clean as possible.

The compressed air supply line to the spray gun must be fitted with a filter

capable of removing any oil or water together with a suitable pressure

regulator.

Higher pressure and contaminated air will shorten the spray gun life due to

faster wear and could become a safety hazard.

Water in the air line will also cause damage and may contaminate the paint

being used. Therefore ensure the air supply is properly filtered.

Line pressure, or supply hose inside diameter, should be increased to

compensate for unusually long air hoses (over 10 m). Minimum hose diameter

should be 6mm (¼") ID, and fittings should have the same inside dimensions.

The air inlet used for connecting air supply has a standard ¼” BSP thread.

Container Volume

100 ml

Air Inlet Connection

1/4” BSP

Minimum Compressor Size

3 HP

Typical Operating Pressure

30-43 psi

Maximum Operating Pressure

50 psi

Paint Delivery

65-100 ml/min

Weight

373 g

Depth x Width x Height

245 x 125 x 65m

Air Consumption

80 l/min

Nozzle Size

0.8 mm