ST7LITE1XB datasheet(148/157 Pages) STMICROELECTRONICS

148 / 157 page

ST7LITE1xB

148/157

15 DEVICE CONFIGURATION AND ORDERING INFORMATION

Each device is available for production in user pro-

grammable versions (FLASH).

ST7FLITE1xB devices are shipped to customers

with a default program memory content (FFh).

This implies that FLASH devices have to be con-

figured by the customer using the Option Bytes.

15.1 OPTION BYTES

The two option bytes allow the hardware configu-

ration of the microcontroller to be selected.

The option bytes can be accessed only in pro-

gramming mode (for example using a standard

ST7 programming tool).

OPTION BYTE 0

OPT7 = Reserved, must always be 1.

OPT6 = PKG Package selection

0: 16-pin package

1: 20-pin package

OPT5:4 = CLKSEL Clock Source Selection

When the internal RC oscillator is not selected

(Option OSC=1), these option bits select the clock

source: resonator oscillator or external clock

Note: When the internal RC oscillator is selected,

the CLKSEL option bits must be kept at their de-

fault value in order to select the 256 clock cycle

delay (see Section 7.5).

OPT3:2 = SEC[1:0] Sector 0 size definition

These option bits indicate the size of sector 0 ac-

cording to the following table.

OPT1 = FMP_R Read-out protection

Readout protection, when selected provides a pro-

tection against program memory content extrac-

tion and against write access to Flash memory.

Erasing the option bytes when the FMP_R option

is selected will cause the whole memory to be

erased first and the device can be reprogrammed.

Refer to the ST7 Flash Programming Reference

Manual and section 4.5 on page 14 for more de-

tails

0: Read-out protection off

1: Read-out protection on

OPT0 = FMP_W FLASH write protection

This option indicates if the FLASH program mem-

ory is write protected.

Warning: When this option is selected, the pro-

gram memory (and the option bit itself) can never

be erased or programmed again.

0: Write protection off

1: Write protection on

Clock Source

Port C

CLKSEL

Resonator

Ext. Osc Enabled/

Port C Disabled

Ext.

Clock source:

CLKIN

on PB4

Ext. Osc Disabled/

Port C Enabled

on PC0

Reserved

Sector 0 Size

SEC1

SEC0

0.5k

OPTION BYTE 0

OPTION BYTE 1

Res. PKG

CLKSEL

SEC1 SEC0

FMP

PLL

x4x8

PLL

OFF

PLL32

OFF

OSC LVD1 LVD0

WDG

HALT

Default

Value

1111

0111

ST7LITE1XB bảng dữ liệu(PDF) 148 Page - STMicroelectronics

ST7LITE1XB bảng dữ liệu(HTML) 148 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL