Installation for CE Compliance
To maintain compliance with the requirements of the EMC Directive (89/336/EEC), this product
must be correctly installed. The PC in which the board is housed must be CE compliant as
declared by the PC manufacturer. The type of external I/O cable can be chosen according to the
notes below:
1.
Remove the cover of the PC observing any additional instructions of the PC manufacturer
2.
Locate the board in a spare ISA slot and press gently but firmly into place
3.
Ensure that the metal bracket attached to the board is fully seated
4.
Fit the bracket clamping screw and firmly tighten this on the bracket
NOTE: Good contact of the bracket to chassis is essential
5.
Replace the cover of the PC observing any additional instructions of the PC manufacturer
Cable
Cable length 1Metre or less
:
Ribbon cable satisfactory
Cable length 1M to 3M
:
Commercial screened cable gives the protection required
Longer cable or noisy environment :
Use
fully
screened
cable
with
metal
backshells
e.g. Arcom CAB50CE
The following standards have been applied to this product:
BS EN50081-1: 1992 Generic Emissions Standard, Residential, Commercial, Light Industry
BS EN50082-1: 1992 Generic Immunity Standard, Residential, Commercial, Light Industry
BS EN55022 : 1995 ITE Emissions, Class B, Limits and Methods
11
2192-09066-000-000
J206 PCIB40 Technical Manual
Vietnamese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
