| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
ST72361 bảng dữ liệu(PDF) 21 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST72361 bảng dữ liệu(HTML) 21 Page - STMicroelectronics |
|
21 / 224 page ![]() ST72361 21/224 6.2 MULTI-OSCILLATOR (MO) The main clock of the ST7 can be generated by two different source types coming from the multi- oscillator block: ■ an external source ■ a crystal or ceramic resonator oscillator Each oscillator is optimized for a given frequency range in terms of consumption and is selectable through the option byte. The associated hardware configuration are shown in Table 6. Refer to the electrical characteristics section for more details. Caution: The OSC1 and/or OSC2 pins must not be left unconnected. For the purposes of Failure Mode and Effect Analysis, it should be noted that if the OSC1 and/or OSC2 pins are left unconnected, the ST7 main oscillator may start and, in this con- figuration, could generate an fOSC clock frequency in excess of the allowed maximum (> 16 MHz), putting the ST7 in an unsafe/undefined state. The product behavior must therefore be considered undefined when the OSC pins are left unconnect- ed. External Clock Source In external clock mode, a clock signal (square, si- nus or triangle) with ~50% duty cycle has to drive the OSC1 pin while the OSC2 pin is tied to ground. Crystal/Ceramic Oscillators This family of oscillators has the advantage of pro- ducing a very accurate rate on the main clock of the ST7. The selection within a list of five oscilla- tors with different frequency ranges must be done by option byte in order to reduce consumption (re- fer to Section 14.1 on page 210 for more details on the frequency ranges). The resonator and the load capacitors must be placed as close as possible to the oscillator pins in order to minimize output dis- tortion and start-up stabilization time. The loading capacitance values must be adjusted according to the selected oscillator. These oscillators are not stopped during the RESET phase to avoid losing time in the oscillator start-up phase. Table 6. ST7 Clock Sources Hardware Configuration OSC1 OSC2 EXTERNAL ST7 SOURCE OSC1 OSC2 LOAD CAPACITORS ST7 CL2 CL1 |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |