Typical Performance Characteristics

www.vishay.com

Vishay Sprague

Revision: 19-Sep-2022

3

Document Number: 40194

For technical questions, contact: tantalum@vishay.com

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000

MECHANICAL PERFORMANCE CHARACTERISTICS

ITEM

CONDITION

POST TEST PERFORMANCE

Terminal strength /

Shear force test

Apply a pressure load of 5 N for 10 s ± 1 s horizontally

to the center of capacitor side body AEC-Q200-006

Capacitance change

Dissipation factor

Leakage current

Within ± 10 % of initial value

Initial specified limit

Initial specified limit

There shall be no mechanical or visual damage to

capacitors post-conditioning.

Vibration

MIL-STD-202, method 204, condition D,

10 Hz to 2000 Hz, 20 g peak, 8 h, at rated voltage

Electrical measurements are not applicable, since the

same parts are used for shock (specified pulse) test.

There shall be no mechanical or visual damage to

capacitors post-conditioning.

Shock

(specified pulse)

MIL-STD-202, method 213, condition I,

100 g peak

Capacitance change:

Cap.

≤ 600 μF

Cap. > 600 μF

Dissipation factor

Leakage current

Within ± 10 % of initial value

Within ± 20 % of initial value

Initial specified limit

Initial specified limit

There shall be no mechanical or visual damage to

capacitors post-conditioning.

Resistance

to solder heat

MIL-STD-202, method 210, condition J

(SnPb terminations) and K (lead (Pb)-free terminations),

one heat cycle

Capacitance change

Dissipation factor

Leakage current

Within ± 10 % of initial value

Initial specified limit

Initial specified limit

Solderability

EIA / IPC / JEDEC J-STD-002

Test B (SnPb) and B1 (lead (Pb)-free).

Preconditioning per category C.

Capacitors with SnPb and lead (Pb)-free terminations

are backward and forward compatible.

Does not apply to gold terminations.

Solder coating of all capacitors shall meet specified

requirements.

There shall be no mechanical or visual damage to

capacitors post-conditioning.

Flammability

Encapsulation materials meet UL 94 V-0 with an

oxygen index of 32 %

Downloaded from

Arrow.com.