1030 MicroCal Voltage & Current Source

Time Electronics

Calibration, Test & Measurement

 10mV, 100mV, 1V ranges

 10mA, 100mA ranges

 0.1% accuracy

 0 - 8V available

 Precision 10-turn dial

 Battery Powered 9V PP3

 Battery level indicator

The 1030 is a compact, low cost, portable voltage and current calibrator for general purpose

signal injection. It is suitable for voltage and current loop signal simulation as well as

thermocouple simulation. The precision 10-turn dial provides a conventional feel to setting

the output with a setting resolution of 1 part in a 1000 (0.1%)

Three voltage ranges give an adjustable output from 10uV to 1V and two current ranges for

10uA to 100mA.

An additional 0 to 8V output can be obtained by using a precision 1Kohm resistor that is

supplied with the unit. The resistor is connected across the output terminals and the 10mA

current range selected. This allows the output to be set between 0 and +/- 8V with a 10mV

resolution and an accuracy of 0.3% of full scale.

The 1030 is simple to operate and does not require any standardisation prior to use. The

operator needs only to switch on, check the battery condition, and set the required range and

output value.

The 1030 is supplied with a leatherette carry case.

Time Electronics, Botany Industrial Est. Tonbridge, Kent. England. TN9 1RH.

Tel: +44 (0)1732 355993 Fax: +44 (0)1732 770312 E-mail: mail@timeelectronics.co.uk

www.timeelectronics.com

V1b 20/06/08