TDS 310, TDS 320 & TDS 350 Instruction Manual
43
Warranted Characteristics
Warranted characteristics are described in terms of quantifiable performance
limits that are warranted. This subsection lists only warranted characteristics.
NOTE
In these tables, those warranted characteristics that are checked in
the Performance Tests, starting on page 611, appear in boldface
type under the column Name.
The electrical characteristics found in these tables of warranted characteris
tics apply when the oscilloscope has been adjusted at an ambient tempera
ture between +20_ C and +30_ C, has had a warmup period ofat least
20 minutes, and is operating at an ambient temperature between -10_ C and
+55_ C (unless otherwise noted).
Table41:Warranted Characteristics
Signal Acquisition System
Name
Description
Accuracy, DC Voltage Measurement,
Average Acquisition Mode
Measurement Type
Average of ≥16 waveforms
Delta volts between any two aver
ages of ≥16 waveforms acquired
under the same setup and ambi
ent conditions
DC Accuracy
±(2.0% |(reading -
Net Offset)| + Offset
Accuracy + 0.1 div)
±(2.0% |reading| + 0.15 div
+ 0.3 mV)
Accuracy, DC Gain, Sample or
Average Acquisition Modes
±2%
Pulse Response, Peak Detect and
Envelope Mode
Sec/Div Setting
5 s/div - 25 ms/div
TDS 310:10 ms/div - 10 ns/div
TDS 320:10 ms/div - 5 ns/div
TDS 350:10 ms/div - 2.5 ns/div
Minimum Pulse Width
10 ns
The greater of10 ns or
.02 sec/div setting
Performance
Conditions
Vietnamese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
