1 Getting Started

ST7-EPB

8/15

UM0028 Rev 4

4.

Lock the device in place by lowering the lever again.

Use

its use, refer to the software’s online help.

1.4

Using an in-circuit programming connection

Some ST7-EPB programmers allow in-circuit programming (ICP) of supported ST7 Flash

microcontrollers, thanks to the In-Circuit Communication (ICC) protocol developed for ST7.

Figure 3.

Installing MCU in a ZIF socket

Pin 1 indicator

Pin 1 indicator

Pin

This section provides information to help you setup your application

board for in-circuit programming of your ST7.

To take advantage of ICP you must have an ICC connector (10-pin

HE-10 type) installed on your application board allowing you to

connect it to your programming board with the provided ICC cable

(10-pin ribbon cable). This connection is illustrated in

Figure 4.

HE-10 type connector

Figure 4.

In-Circuit Communication interface