TH8082

Enhanced SoloLIN Transceiver

TH8082 – Datasheet

Page 1 of 26

3901008082

Feb 2007

Rev 007

Features

Compatible to LIN Physical Layer Specification Rev.1.3 and 2.0

Compatible to ISO9141 functions

Very low standby current consumption of 6.5µA in sleep mode

Remote wake up via bus traffic

Baud rate up to 20 kBaud

Control output for voltage regulator with low on – resistance for switchable master

termination

Low EME due to slew rate control

High EMI immunity

Fully integrated receiver filter

Bus terminals proof against short-circuits and transients in the automotive environment

High impedance Bus pin in case of loss of ground and undervoltage condition

Bus short to ground protection

Thermal overload protection

Integrated termination resistor for LIN slave nodes

High signal symmetry for using in RC – based slave nodes up to 2% clock tolerance

±4kV ESD protection

Ordering Information

Part No.

Temperature Range

Package

TH8082 KDC

K (-40 to 125 °C)

DC (SOIC8)

General Description

The TH8082 is a physical layer device for a single wire data link capable of operating in applications where

high data rate is not required and a lower data rate can achieve cost reductions in both the physical media

components and in the microprocessor which use the network. The TH8082 is designed in accordance to the

physical layer definition of the LIN Protocol Specification, Rev. 1.3 and 2.0.The IC furthermore can be used

in ISO9141 systems.

Because of the very low current consumption of the TH8082 in the sleep mode it’s suitable for ECU

applications with hard standby current requirements. This mode allows a shutdown of the whole application.

The included wake-up function detects incoming dominant bus messages and enables the voltage regulator.