TLV313 datasheet(21/44 Pages) TI2

21 / 44 page

5 kW

10-mA max

V+

OUT

OVERLOAD

Device

OUT

2pRC

3 dB

R = R

C = C

Q = Peaking factor

(Butterworth Q = 0.707)

G =

(

2 -

TLV313, TLV2313, TLV4313

www.ti.com

SBOS753B – JUNE 2016 – REVISED FEBRUARY 2017

Product Folder Links: TLV313 TLV2313 TLV4313

Submit Documentation Feedback

System Examples (continued)

If even more attenuation is needed, a multiple pole filter is required. The Sallen-Key filter may be used for this

task, as shown in Figure 23. For best results, the amplifier must have a bandwidth that is eight to 10 times the

filter frequency bandwidth. Failure to follow this guideline may result in phase shift of the amplifier.

Figure 23. Two-Pole, Low-Pass, Sallen-Key Filter

10 Power Supply Recommendations

The TLVx313 family is specified for operation from 1.8 V to 5.5 V (±0.9 V to ±2.75 V); many specifications apply

from –40°C to +125°C. The Typical Characteristics section presents parameters that may exhibit significant

variance with regard to operating voltage or temperature.

CAUTION

Supply voltages larger than 7 V can permanently damage the device (see the Absolute

Maximum Ratings table).

Place 0.1-μF bypass capacitors close to the power-supply pins to reduce errors coupling in from noisy or high-

impedance power supplies. For more detailed information on bypass capacitor placement, refer to the Layout

Guidelines section.

10.1 Input and ESD Protection

The TLV313 family incorporates internal electrostatic discharge (ESD) protection circuits on all pins. In the case

of input and output pins, this protection primarily consists of current-steering diodes connected between the input

and power-supply pins. The ESD protection diodes also provide in-circuit, input overdrive protection, as long as

the current is limited to 10 mA as stated in the Absolute Maximum Ratings. Figure 24 shows how a series input

resistor may be added to the driven input to limit the input current. The added resistor contributes thermal noise

at the amplifier input and the value must be kept to a minimum in noise-sensitive applications.

Figure 24. Input Current Protection

TLV313 bảng dữ liệu(PDF) 21 Page - Texas Instruments

TLV313 bảng dữ liệu(HTML) 21 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

bảng dữ liệu tải về

Link URL