Page <1>

V1.0

09/10/20

Multipurpose Enclosures

Newark.com/multicomp-pro

Farnell.com/multicomp-pro

Element14.com/multicomp-pro

Specifications

Polycarbonate Material:

Moulded in

: Light Grey.

Operating Temperature

: -40°C to +120°C

High impact ABS Material:

Moulded in

: Dark Grey.

Suggested Operating Temperature : -20°C to 80°C.

The lid and base incorporate a tongue and groove sealing system with a neoprene gasket.

Wall mounting holes and lid fixing screws are outside the sealing area thus preventing the ingress of moisture and dust.

Designed to IP 65 of IEC 529 and nema 4 (dust and hoseproof).

Available with clear or light grey LIDS.

Internal guide slots for mounting PCB assemblies vertically.

Bosses on internal base allow fixing of PCB’s horizontally or connection of terminals, etc into threaded brass inserts.

Lid fixing screw are M-4 stainless steel (nonmagnetic) into threaded brass inserts.

Specifications Table

Colour

Material

External

Dimensions

(mm)

Part Number

Dark Grey

ABS

64 × 58 × 35

G302

115 × 65 × 40

G304

115 × 65 × 55

G308

115 × 90 × 55

G311

171 × 121 × 55

G313

222 × 146 × 55

G317

115 × 90 × 80

G331

171 × 121 × 80

G340

195 × 80 × 55

G346

222 × 146 × 75

G353

52 × 50 × 35

G362

82 × 80 × 55

G366

Colour

Material

External

Dimensions

(mm)

Part Number

160 × 80 × 55

G368

200 × 120 × 75

G373

265 × 185 × 95

G378

120 × 120 × 60

G386

120 × 120 × 90

G387

160 × 160 × 60

G396

160 × 160 × 90

G399

240 × 160 × 90

G3008

240 × 160 × 120

G3019

300 × 230 × 86

G3028

300 × 230 × 111

G3031

360 × 200 × 150

G3039

Important Notice : This data sheet and its contents (the “Information”) belong to the members of the AVNET group of companies (the “Group”) or are licensed to it. No licence is granted for

the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change

without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness,

any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make

any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or

where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its

negligence. Multicomp Pro is the registered trademark of Premier Farnell Limited 2019.