STPM11ATR datasheet(20/46 Pages) STMICROELECTRONICS

20 / 46 page

Theory of operation

STPM11, STPM12, STPM13, STPM14

20/46

Doc ID 13167 Rev 8

bias currents and voltages for all other analog modules and for the OTP module. The

bandgap voltage temperature behavior can be changed in order to better compensate the

variation of sensor sensitivity with temperature. This task is performed with the BGTC

configuration bits.

7.7

Load monitoring

The STPM1X include a no-load condition detection circuit with adjustable threshold. This

circuit monitors the voltage and the current channels and, when the measured power is

below the set threshold, the internal signal BIL becomes high. The information about this

signal is also available in the status bit BIL.

The no load condition occurs when the product between VRMS and IRMS input values is

below a given value. This value can be set with the LTCH configuration bits, and it is also

dependent on the selected current gain (Ai) and the calibration registers constant Kp=Kv*Ki.

Four different no-load threshold values can be chosen according to the two configurations

bits LTCH (see Table 12).

When a no-load condition occurs (BIL=1), the integration of power is suspended and the

tamper module is disabled.

If a no-load condition is detected, the BIL signal blocks generation of pulses for stepper and

forces the SCLNLC pin to be low.

Figure 16.

Bandgap temperature variation

Table 12.

No load detection thresholds

LTCH

VRMS * IRMS (input channel voltages)

Rogowski coil (PST<2)

Ct or Shunt (PST>1)

0.004488 / (Ai*Kp)

0.003648 / (Ai*Kp)

0.008976 / (Ai*Kp)

0.007296 / (Ai*Kp)

0.017952 / (Ai*Kp)

0.014592 / (Ai*Kp)

0.035904 / (Ai*Kp)

0.029184 / (Ai*Kp)

Obsolete

Product(s)

- Obsolete

Product(s)

STPM11ATR bảng dữ liệu(PDF) 20 Page - STMicroelectronics

STPM11ATR bảng dữ liệu(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

bảng dữ liệu tải về

Link URL