8.6 Glossary

TI Glossary

This glossary lists and explains terms, acronyms, and definitions.

9 Revision History

NOTE: Page numbers for previous revisions may differ from page numbers in the current version.

Changes from Revision * (October 1997) to Revision A (December 2024)

Page

• Added Pin Functions table, Recommended Operating Conditions table, Thermal Information table, Detailed

Description section, Application and Implementation section, Power Supply Recommendations section,

Layout section, and the Device and Documentation Support section................................................................ 1

• Changed names on pins 2, 3, 4, 6, and 7 from: VIN–, VIN+, V–, VO and V+ to: –IN, +IN, –VS, OUT and +VS...3

• Added dual supply specification to Absolute Maximum Ratings ....................................................................... 4

• Added note clarifying output short-circuit "to ground" in Absolute Maximum Ratings refers to short-circuit to

VS / 2.................................................................................................................................................................. 4

• Added test condition of TA =–40℃ to +85℃ to input bias current drift and input offset current drift parameter

in Electrical Characteristics ............................................................................................................................... 5

• Changed parameter from Offset Voltage RTI vs Power Supply to Power Supply Rejection Ratio in Electrical

Characteristics ...................................................................................................................................................5

• Changed parameter from Input Impedance to Differential impedance and Common-mode impedance in

Electrical Characteristics ................................................................................................................................... 5

• Added test condition to input bias current parameter in Electrical Characteristics ............................................5

• Changed voltage noise from 2µVpp to 2.7µVpp in Electrical Characteristics ..................................................... 5

• Changed Bandwidth, –3dB at G = 5 from 120kHz to 100kHz in Electrical Characteristics ............................... 5

• Changed Bandwidth, –3dB G = 100 from 5kHz to 3kHz in Electrical Characteristics ....................................... 5

• Added test condition to Slew rate parameter in Electrical Characteristics ........................................................ 5

• Changed falling Slew rate from 0.16V/µs to 0.12V/µs in Electrical Characteristics ...........................................5

• Changed Overload recovery from 3µs to 22µs in Electrical Characteristics ..................................................... 5

• Updated Quiescent Current vs Temperature curve in Typical Characteristics section....................................... 7

• Changed Offset Trimming section.................................................................................................................... 14

10 Mechanical, Packaging, and Orderable Information

The following pages include mechanical, packaging, and orderable information. This information is the most

current data available for the designated devices. This data is subject to change without notice and revision of

this document. For browser-based versions of this data sheet, refer to the left-hand navigation.

INA122

SBOS069A – OCTOBER 1997 – REVISED DECEMBER 2024

www.ti.com

22

Submit Document Feedback

Copyright © 2024 Texas Instruments Incorporated

Product Folder Links: INA122