MB85RS64 datasheet(2/31 Pages) RAMXEED

2 / 31 page

MB85RS64

DS501-00012-7v2-E



PIN ASSIGNMENT



PIN FUNCTIONAL DESCRIPTIONS

Pin No. Pin Name

Functional description

Chip Select pin

This is an input pin to make chip select. When CS is the “H” level, device is in deselect

(standby) status and SO becomes High-Z. Inputs from other pins are ignored at this time.

When CS is the “L” level, device is in select (active) status. CS has to be the “L” level

before inputting op-code. The Chip Select pin is pulled up internally to the VDD pin.

Write Protect pin

This is a pin to control writing to a status register. The writing of status register (see “

STATUS REGISTER”) is protected in related with WP and WPEN. See “WRITING

PROTECT” for detail.

HOLD

Hold pin

This pin is used to interrupt serial input/output without making chip deselect. When

HOLD is the “L” level, hold operation is activated, SO becomes High-Z, and SCK and SI

become don’t care. While the hold operation, CS shall be retained the “L” level.

SCK

Serial Clock pin

This is a clock input pin to input/output serial data. SI is loaded synchronously to a rising

edge, SO is output synchronously to a falling edge.

Serial Data Input pin

This is an input pin of serial data. This inputs op-code, address, and writing data.

Serial Data Output pin

This is an output pin of serial data. Reading data of FeRAM memory cell array and status

VDD

Supply Voltage pin

GND

Ground pin

GND

VDD

SCK

HOLD

(TOP VIEW)

(8-pin plastic SOP,150mil)

MB85RS64 bảng dữ liệu(PDF) 2 Page - RAMXEED LIMITED