Micro Lipo USB Charger Wiki –

DFRobot

SKU:DFR0667

Introduction

This Charger - MicroUSB is designed for single-cell 3.7V lithium battery. With its tiny body,

you can easily integrate it into your applications. The charger adopts TP4056X lithium battery

charging IC, which guarantees you quick and safe charging. Three output current modes can be

easily switched by selecting different bonding pads on the backside (The default output current is

set to 50mA). The thermal feedback inside the TP4056X can automatically adjust the charging

current to limit the chip temperature under high power operation or high ambient temperature

conditions.

Plug this charger into power source via its micro USB port, the LED on the charger will flash

when no battery is not connected; keep on when charging and go off when the battery is fully

charged. So, this LED would consume nothing of your battery. Meanwhile, you could plug an

external indicator so that it would be convenient to check the charging situation when the charger

module is integrated into your applications.

There are 3 charging stages provided: trickle charge, constant current charge and constant

voltage charge, which guarantee the safety and save the time.

NOTE: Low current mode can be used to charge a large capacity battery but high current

mode cannot be used to charge a small capacity battery. The battery may explode if the charging

current is too high.