*/

const unsigned char wake[24]={

0x55, 0x55, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00, 0x00, \

0x00, 0x00, 0x00, 0x00, 0x00, 0x00, 0xff, 0x03, 0xfd, 0xd4, 0x14, 0x01, 0x17,

0x00};//wake up NFC module

const unsigned char firmware[9]={

0x00, 0x00, 0xFF, 0x02, 0xFE, 0xD4, 0x02, 0x2A, 0x00};//

const unsigned char tag[11]={

0x00, 0x00, 0xFF, 0x04, 0xFC, 0xD4, 0x4A, 0x01, 0x00, 0xE1, 0x00};//detecti

ng tag command

const unsigned char std_ACK[25] = {

0x00, 0x00, 0xFF, 0x00, 0xFF, 0x00, 0x00, 0x00, 0xFF, 0x0C, \

0xF4, 0xD5, 0x4B, 0x01, 0x01, 0x00, 0x04, 0x08, 0x04, 0x00, 0x00, 0x00, 0x00,

0x4b, 0x00};

unsigned char old_id[5];

unsigned char receive_ACK[25];//Command receiving buffer

//int inByte = 0;

//incoming serial byte buffer

#if defined(ARDUINO) && ARDUINO >= 100

#include "Arduino.h"

#define print1Byte(args) Serial1.write(args)

#define print1lnByte(args)

Serial1.write(args),Serial1.println()

#else

#include "WProgram.h"

#define print1Byte(args) Serial1.print(args,BYTE)

#define print1lnByte(args)

Serial1.println(args,BYTE)

#endif

void setup(){

Serial.begin(9600);

// open serial with PC

Serial1.begin(115200);

//open serial1 with device

//Serial2.begin(115200);

wake_card();

delay(100);