Introduction

RSSD interface units for pre-assembled leads with

SUB-D plug connectors to IEC 807-2/DIN 41652

Passive interface unit for 9 … 50 signals for adapting pre-

assembled leads with SUB-D plug to IEC 807-2/DIN 41652

to screw or tension clamp connection systems.

The components are supplied with either female or male

connectors. A spacer block between plug connector and PCB

cushions the mechanical forces occurring between the

connected cables. RSSD interface units can be supplied with an

ground terminal for shielded leads as an optional feature.

An additional test point simplifies testing and measuring during

initial setup and when servicing the system.

RS VERT interface units as voltage distributor

Passive interface units for the distribution of dc supply voltage.

These interface units are available in three designs for distribution

to 8, 16 and 72 connections, for positive and negative

voltages in each case:

• 8x and 16x distributor just 45 mm wide overall, 72x distributor

100 mm wide

• Fed by two connection elements for positive and negative

voltages in each case

• Fits on TS32/35 mounting rails

RS VERT voltage distributors can also be used in small

enclosures and provide clearly organized distribution.

RS ELCO interface units for pre-assembled leads with

hermaphrodite plug connector system

Weidmuller’s passive interface units are used for adapting

hermaphrodite ELCO multi-pole connectors, for input and

output, to screw terminal systems. The hermaphrodite contact

is a fork-type contact that is identical in design on both sides of

the connection, but with one fork turned through 90° to engage

with the other.

RS RJ45 interface units for connecting data lines

The RS RJ45 interface module offers the user a convenient,

easy-to-use interface for connecting modems, notebooks and

other office equipment in the electrical cabinet.

The module converts the standard RJ45 connection to a screw

terminal system or acts as a coupling to connect data leads by

means of two RJ45 sockets. For data transmission rates of up

to 100 Mbps, it is advisable to connect one end of the shield of

the data cable to a protective ground. The interface modules can

be fitted on TS 32/35 mounting rails.

A

A.3