0.01

0.1

1.0

10

100

CONVERSION RATE (Hz)

400

600

800

1000

1200

140

0

1600

1800

2000

LM89

SNIS128D – AUGUST 2002 – REVISED JUNE 2014

www.ti.com

Feature Description (continued)

Figure 4. Conversion Rate Effect On Power Supply Current

9.3.2 The ALERT Output

The LM89's ALERT pin is an active-low open-drain output that is triggered by a temperature conversion that is

outside the limits defined by the temperature setpoint registers. Reset of the ALERT output is dependent upon

the selected method of use. The LM89's ALERT pin is versatile and will accommodate three different methods of

use to best serve the system designer: as a temperature comparator, as a temperature based interrupt flag, and

as part of an SMBus ALERT system. The three methods of use are further described below. The ALERT and

interrupt methods are different only in how the user interacts with the LM89.

Each temperature reading (LT and RT) is associated with a T_CRIT setpoint register (LCS, RCS), a HIGH

setpoint register (LHS and RHS) and a LOW setpoint register (LLS and RLS). At the end of every temperature

reading, a digital comparison determines whether that reading is above its HIGH or T_CRIT setpoint or below its

LOW setpoint. If so, the corresponding bit in the STATUS REGISTER is set. If the ALERT mask bit is not high,

any bit set in the STATUS REGISTER, with the exception of Busy (D7) and OPEN (D2), will cause the ALERT

output to be pulled low. Any temperature conversion that is out of the limits defined by the temperature setpoint

registers will trigger an ALERT. Additionally, the ALERT mask bit in the Configuration register must be cleared to

trigger an ALERT in all modes.

9.3.2.1

ALERT Output As A Temperature Comparator

When the LM89 is implemented in a system in which it is not serviced by an interrupt routine, the ALERT output

could be used as a temperature comparator. Under this method of use, once the condition that triggered the

ALERT to go low is no longer present, the ALERT is de-asserted (Figure 5). For example, if the ALERT output

was activated by the comparison of LT > LHS, when this condition is no longer true the ALERT will return HIGH.

This mode allows operation without software intervention, once all registers are configured during set-up. In order

for the ALERT to be used as a temperature comparator, bit D0 (the ALERT configure bit) in the FILTER and

ALERT CONFIGURE REGISTER (BFh) must be set high. This is not the power-on-default state.

10

Submit Documentation Feedback

Copyright © 2002–2014, Texas Instruments Incorporated

Product Folder Links: LM89