PAXUSB00 datasheet(9/36 Pages) REDLION

9 / 36 page

PAXP Jumper Selection

PAXS Jumper Selection

REAR TERMINALS

SOURCE

SINK

USER INPUT LOGIC JUMPER

JUMPER SELECTIONS

The

indicates factory setting.

Main

Circuit

Board

USER INPUT

JUMPER

LOCATION

Main

Circuit

Board

JUMPER

LOCATION

JUMPER

LOCATION

USER INPUT

INPUT RANGE

BRIDGE

10V

SINK

SOURCE

±240mV

±24mV

INPUT RANGE

USER INPUT

BRIDGE

EXCITATION

REAR TERMINALS

JUMPER SELECTIONS

The

indicates factory setting.

Bridge Excitation

One jumper is used to select bridge excitation to allow use of the higher sensitivity 24 mV input

range. Use the 5 V excitation with high output (3 mV/V) bridges. The 5 V excitation also reduces

bridge power compared to 10 V excitation.

A maximum of four 350 ohm load cells can be driven by the internal bridge excitation voltage.

PAXH Jumper Selection

REAR TERMINALS

20 mA

200 µA

2 mA

200 mA

INPUT RANGE

20 V

.2V/2V

300 V

SIGNAL

VOLTAGE: OFF

CURRENT: ON

COUPLE

AC: OFF

DC: ON

SOURCE

SINK

USER INPUT

2 V ONLY

JUMPER SELECTIONS

The

indicates factory setting.

Signal Jumper

One jumper is used for the input signal type. For current signals, the jumper

is installed. For voltage signals, remove the jumper from the board. (For 2 V

inputs, this removed jumper can be used in the “2 V only” location.)

Couple Jumper

One jumper is used for AC / DC couple. If AC couple is used, then the jumper

is removed from the board. If DC couple is used, then the jumper is installed.

Input Range Jumper

For most inputs, one jumper is used to select the input range. However, for

the following ranges, set the jumpers as stated:

5 A: Remove all jumpers from the input range.

2 V: Install one jumper in “.2/2V” position and one jumper in “2 V only”.

All Other Ranges: One jumper in the selected range only.

Do not have a jumper in both the voltage and current ranges at the same time.

Avoid placing a jumper across two ranges.

CAUTION: To maintain the electrical safety of the meter, remove

unneeded jumpers completely from the meter. Do not move the

jumpers to positions other than those specified.

Main

Circuit

Board

Jumper

Locations

CURR/VOLT

SIGNAL

2 V ONLY

USER INPUT

AC/DC COUPLE

VOLTAGE

CURRENT

RANGES

PAXUSB00 bảng dữ liệu(PDF) 9 Page - Red Lion Controls. Inc

PAXUSB00 bảng dữ liệu(HTML) 9 Page - Red Lion Controls. Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

bảng dữ liệu tải về

Link URL