| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
ACT72350 bảng dữ liệu(PDF) 27 Page - Qorvo, Inc |
|
|
|||||||||||||||||||||||||||||
ACT72350 bảng dữ liệu(HTML) 27 Page - Qorvo, Inc |
|
27 / 97 page ![]() ACT72350 Data Sheet 160V 3 Phase BLDC Motor Driver Data Sheet v1.1, 2025-02-17 Subject to change without notice 27 of 97 www.qorvo.com ® microcontroller upon re-initialization to determine the cause of previous reset. This information is stored within the SOC.FAULT.TMPFLT bit A power monitoring signal VMON is provided onto the AIO6 buffered output for monitoring various internal power supplies. VMON can be set to be one of the following monitored supplies: 0.4•VCC33, 0.4•VCCIO, 0.4•VSYS, VPTAT1 or 0.1•VP. For power and temperature warning, an IC temperature warning event at 140°C are provided as a maskable interrupt source into the application microcontroller, through the nFAULT output. This warning could be employed to instruct the microcontroller to safely power down the system. To allow Temperature Warning assertions on the nFAULT open drain output, write to the SOC.FAULTENABLE.nTMPWARN bit. Alternatively, the external microcontroller can obtain the real time status temperature warning bit by reading the SOC.FAULT.TMPWARN bit. If the Temperature Warning fault issues a fault message, the state of this fault is latched within the SOC.FAULT.TMPWARN_LATCH. In addition to the temperature warning interrupt and fault reset, a temperature monitor signal is provided onto the AIO6 buffered output as an analog signal, which the application microcontroller can choose to capture using its ADC resource, as a means to measure internal die temperature. 11.10 Voltage Reference The reference block includes a 1.2V high-precision reference voltage used internally and for all the LDOs. There is also a high-accuracy 2.5V/3.0V programmable reference for the ADC VREF. There is also a 4- level programmable threshold voltage VTHREF (0.1V, 0.2V, 0.5V, and 1.25V) . 1 VPTAT is voltage proportional with absolute temperature from the temperature sensing circuit. The VPTAT voltage can be sampled by the external microcontroller’s ADC through the voltage monitoring MUX at AO6, while AIO6 is in Output Buffer Mode . |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |