MCP3460RT-ESLASH2LX datasheet(3/103 Pages) MICROCHIP

3 / 103 page

 2025 Microchip Technology Inc. and its subsidiaries

DS20006975A page 3

MCP3460R

1.0

ELECTRICAL CHARACTERISTICS

Absolute Maximum Ratings(†)

, AVDD ......................................................................................................................................................-0.3 to 4.0V

Digital Inputs and Outputs w.r.t. DGND ............................................................................................ -0.3V to DVDD + 0.3V

Analog Inputs w.r.t. AGND .................................................................................................................-0.3V to AVDD + 0.3V

Current at Input Pins ...............................................................................................................................................±5 mA

Current at Output and Supply Pins ......................................................................................................................±20 mA

Storage Temperature ..............................................................................................................................-65°C to +150°C

Ambient Temperature with Power Applied ..............................................................................................-65°C to +125°C

Soldering Temperature of Leads (10 seconds) ..................................................................................................... +300°C

Maximum Junction Temperature (TJ)........................................................................................... .........................+150°C

ESD on All Pins (HBM)

  6.0 kV

†Notice: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the

device. This is a stress rating only and functional operation of the device at those or any other conditions, above

those indicated in the operational listings of this specification, is not implied. Exposure to maximum rating conditions

for extended periods may affect device reliability.

ELECTRICAL CHARACTERISTICS

Electrical Specifications: Unless otherwise indicated, all parameters apply at AVDD = 2.7V to 3.6V, DVDD = 2.7V to AVDD +0.1V,

MCLK = 4.9152 MHz, VREF =AVDD, ADC_MODE[1:0] = 11. All other register map bits to their default conditions,

TA = -40°C to +125°C, VIN = -0.5 dBFS at 50 Hz.

Parameters

Sym.

Min.

Typ.

Max.

Units

Conditions

Supply Requirements

Analog Operating Voltage

AVDD

2.7

—

3.6

Digital Operating Voltage

DVDD

2.7

—

AVDD +0.1

DVDD ≤ 3.6V

Analog Operating Current

AIDD

—

0.56

0.81

BOOST[1:0] = 00, 0.5x

—

0.69

0.96

BOOST[1:0] = 01, 0.66x

—

0.93

1.3

BOOST[1:0] = 10, 1x

—

1.65

2.2

BOOST[1:0] = 11, 2x

Analog Operating Current

AIDD

—

0.96

BOOST[1:0] = 00, 0.5x,

VREF = 2.4V internal

—

1.2

BOOST[1:0] = 01, 0.66x,

VREF = 2.4V internal

—

1.6

BOOST[1:0] = 10, 1x,

VREF = 2.4V internal

—

2.5

BOOST[1:0] = 11, 2x,

VREF = 2.4V internal

Digital Operating Current

DIDD

—

0.25

0.37

(Note 8)

Note 1:

This parameter is ensured by design and not 100% tested.

This parameter is ensured by characterization and not 100% tested.

REFIN- must be connected to ground for single-ended measurements.

Full-Scale Range (FSR) = 2 x VREF/GAIN.

This input impedance is due to the internal input sampling capacitor and frequency. This impedance is measured

between the two input pins of the channel selected with the input multiplexer.

Applies to all analog gains. Offset and gain errors depend on analog gain settings. See Section 2.0 “Typical

Performance Curves”.

INL is the difference between the endpoints line and the measured code at the center of the quantization band.

DIDD is measured while no transfer is present on the SPI bus.

An external buffer is recommended for external use.

10: Start-up Time is the reaction time to the SPI command.

11: Settling Time depends on bypass caps on REFIN+/OUT pin.

MCP3460RT-E/2LX bảng dữ liệu(PDF) 3 Page - Microchip Technology

MCP3460RT-E/2LX bảng dữ liệu(HTML) 3 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL