TC74HC423AF datasheet(2/12 Pages) TOSHIBA

tên linh kiện	TC74HC423AF

Giải thích chi tiết về linh kiện	CMOS Digital Integrated Circuit Silicon Monolithic Dual Retriggerable Monostable Multivibrator

PDF	12 Pages

Scroll/Zoom	100%

nhà sản xuất	TOSHIBA [Toshiba Semiconductor]

Trang chủ	http://www.semicon.toshiba.co.jp/eng

Logo

2 / 12 page

TC74HC423AP/AF

2007-10-01

Pin Assignment

IEC Logic Symbol

Block Diagram (Note 1)(Note 2)

Note 1: Cx, Rx, Dx are external

capacitor, resistor, and diode, respectively.

Note 2: External clamping diode, Dx;

The external capacitor is charged to VCC level in the wait state, i.e. when no trigger is applied.

If the supply voltage is turned off, Cx is discharges mainly through the internal (parasitic) diode. If Cx is

sufficiently large and VCC drops rapidly, there will be some possibility of damaging the IC through in rush

current or latch-up. If the capacitance of the supply voltage filter is large enough and VCC drops slowly, the

in rush current is automatically limited and damage to the IC is avoided.

The maximum value of forward current through the parasitic diode is

±20 mA.

In the case of a large Cx, the limit of fall time of the supply voltage is determined as follows:

tf ≥ (VCC − 0.7) Cx/20 mA

(tf is the time between the supply voltage turn off and the supply voltage reaching 0.4 VCC.)

In the event a system does not satisfy the above condition, an external clamping diode (Dx) is needed to

protect the IC from in rush current.

TC74HC423AF bảng dữ liệu(PDF) 2 Page - Toshiba Semiconductor