SC2446AEVB datasheet(17/27 Pages) SEMTECH

17 / 27 page

 2005 Semtech Corp.

www.semtech.com

POWER MANAGEMENT

SC2446A

converter output voltage. This non-random error is

caused by the feedback voltage divider ratio. It cannot

be corrected by the feedback loop.

The following table lists a few standard resistor

combinations for realizing some commonly used output

voltages.

)

(

)

(

)

(

)

(

Only the voltages in boldface can be precisely set with

standard 1% resistors.

From this table, one may also observe that when the

value

o −

−

and its multiples fall into the standard resistor value

chart (1%, 5% or so), it is possible to use standard value

resistors to exactly set up the required output voltage

value.

The input bias current of the error amplifier also causes

an error in setting the output voltage. The maximum

inverting input bias currents of error amplifiers 1 and 2

is -250nA. Since the non-inverting input is biased to 0.5V,

the percentage error in the second output voltage will be

–100% · (0.25

µA) · R

/[0.5 · (R

) ]. To keep

this error below 0.2%, R

< 4k

Ω.

Loop Compensation

SC2446A uses current-mode control for both step-down

channels. Current-mode control is a dual-loop control

system in which the inductor peak current is loosely

controlled by the inner current-loop. The higher gain outer

loop regulates the output voltage. Since the current loop

makes the inductor appear as a current source, the

complex high-Q poles of the output LC networks is split

into a dominant pole determined by the output capacitor

and the load resistance and a high frequency pole. This

pole-splitting property of current-mode control greatly

simplifies loop compensation.

The inner current-loop is unstable (sub-harmonic

oscillation) unless the inductor current up-slope is steeper

than the inductor current down-slope. For stable

operation above 50% duty-cycle, a compensation ramp

is added to the sensed-current. In the SC2446A the

compensation ramp is made duty-ratio dependent. The

compensation ramp is approximately

ramp

The slope of the compensation ramp is then

)

(

The slope of the internal compensation ramp is well above

the minimal slope requirement for current loop stability

and is sufficient for all the applications.

With the inner current loop stable, the output voltage is

then regulated with the outer voltage feedback loop. A

simplified equivalent circuit model of the synchronous

Buck converter with current mode control is shown in

Figure 12.

Figure 12. A simple model of synchronous buck converter

with current mode control.

The transconductance error amplifier (in the SC2446A)

has a gain g

m of 260µA/V. The target of the compensation

design is to select the compensation network consisting

of C

2, C3 and R2, along with the feedback resistors Ro1,

Application Information (Cont.)

SC2446AEVB bảng dữ liệu(PDF) 17 Page - Semtech Corporation

SC2446AEVB bảng dữ liệu(HTML) 17 Page - Semtech Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27

bảng dữ liệu tải về

Link URL