| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
SC1110CSTRT bảng dữ liệu(PDF) 7 Page - Semtech Corporation |
|
|
|||||||||||||||||||||||||||||
SC1110CSTRT bảng dữ liệu(HTML) 7 Page - Semtech Corporation |
|
7 / 12 page ![]() 7 2004 Semtech Corp. www.semtech.com POWER MANAGEMENT SC1110 Soft Start Initially, SS/ENABLE sources 10µA of current to charge an external capacitor. The outputs of the error amplifiers are clamped to a voltage proportional to the voltage on SS/ENABLE. This limits the on-time of the high-side MOSFETs, thus leading to a controlled ramp-up of the output voltages. R DS(ON) Current Limiting The current limit threshold is set by connecting an exter- nal resistor from the V CC supply to OCSET. The voltage drop across this resistor is due to the 200µA internal sink sets the voltage at the pin. This voltage is compared to the voltage at the PHASE node. This comparison is made only when the high-side drive is high to avoid false current limit triggering due to uncontributing measure- ments from the MOSFET’s off-voltage. When the voltage at PHASE is less than the voltage at OCSET, an overcurrent condition occurs and the soft start cycle is initiated. The Applications Information synchronous switcher turns off and SS/ENABLE starts to sink 2µA. When SS/ENABLE reaches 0.8V, it then starts to source 10µA and a new cycle begins. Hiccup Mode During power up, the SS/ENABLE pin is internally pulled low until VCC reaches the undervoltage lockout level of 4.2V. Once V CC has reached 4.2V, the SS/ENABLE pin is released and begins to source 10µA of current to the external soft-start capacitor. As the soft-start voltage rises, the output of the internal error amplifier is clamped to this voltage. When the error signal reaches the level of the internal triangular oscillator, which swings from 1V to 2V at a fixed frequency of 250 kHz, switching occurs. As the error signal crosses over the oscillator signal, the duty cycle of the PWM signal continues to increase until the output comes into regulation. If an over-current con- dition has not occurred the soft-start voltage will con- tinue to rise and level off at about 2.2V. |
|
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |