TMUX7612 datasheet(21/54 Pages) TI

21 / 54 page

6 Parameter Measurement Information

6.1 On-Resistance

The on-resistance of a device is the ohmic resistance between the source (Sx) and drain (Dx) pins of the

device. The on-resistance varies with input voltage and supply voltage. The symbol RON is used to denote

on-resistance. Figure 6-1 shows the measurement setup used to measure RON. Voltage (V) and current (ISD) are

measured using this setup, and RON is computed with RON = V / ISD:

RON

Figure 6-1. On-Resistance Measurement Setup

6.2 Off-Leakage Current

There are two types of leakage currents associated with a switch during the off state:

1. Source off-leakage current.

2. Drain off-leakage current.

Source leakage current is defined as the leakage current flowing into or out of the source pin when the switch is

off. This current is denoted by the symbol IS(OFF).

Drain leakage current is defined as the leakage current flowing into or out of the drain pin when the switch is off.

This current is denoted by the symbol ID(OFF).

Figure 6-2 shows the setup used to measure both off-leakage currents.

GND

Is (OFF)

VDD

VSS

IS(OFF)

GND

VDD

VSS

ID(OFF)

ID (OFF)

Is (OFF)

ID (OFF)

Figure 6-2. Off-Leakage Measurement Setup

www.ti.com

TMUX7612

SCDS466A – AUGUST 2023 – REVISED DECEMBER 2024

Submit Document Feedback

Product Folder Links: TMUX7612

TMUX7612 bảng dữ liệu(PDF) 21 Page - Texas Instruments