SC1109BSTR datasheet(9/19 Pages) SEMTECH

9 / 19 page

 2004 Semtech Corp.

www.semtech.com

POWER MANAGEMENT

SC1109

4) The Output Capacitor(s) (Cout) should be located as

close to the load as possible, fast transient load cur-

rents sre supplied by Cout only, and connections between

Cout and the load must be short, wide copper areas to

minimize inductance and resistance.

5) The SC1109 is best placed over a quiet ground plane

area, avoid pulse currents in the Cin, Q1, Q2 loop flowing

in this area. GND should be returned to the ground plane

close to the package and close to the ground side of

(one of) the output capacitor(s). If this is not possible,

the GND pin may be connected to the ground path be-

tween the Output Capacitor(s) and the Cin, Q1, Q2 loop.

Under no circumstances should GND be returned to a

ground inside the Cin, Q1, Q2 loop.

Vout

Application Information (Cont.)

6) BST for the SC1109 should be supplied from the 12V

supply, the BST pin should be decoupled directly to GND

by a 0.1mF ceramic capacitor, trace lengths should be as

short as possible. If a 12V supply is not available, a classi-

cal boot strap method could be implemented to achieve

the upper MOSFETs gate drive.

7) The Phase connection should be short .

8) Ideally, the grounds for the two LDO sections should

be returned to the ground side of (one of) the output

capacitor(s).

SC1109BSTR bảng dữ liệu(PDF) 9 Page - Semtech Corporation