405GP datasheet(33/59 Pages) AMCC

33 / 59 page

405GP – Power PC 405GP Embedded Processor

AMCC

Revision 2.03 – September 7, 2007

Data Sheet

Signal List

The following table provides a summary of the number of package pins associated with each functional interface

group.

Multiplexed Pins

In the table “Signal Functional Description” on page 35, each external signal is listed along with a description of the

signal function. Some signals are multiplexed on the same pin (ball) so that the pin can be used for different

functions. Multiplexed signals are shown as a default signal with a secondary signal in square brackets (for

example, GPIO1[TS1E]). Active-low signals (for example, RAS) are marked with an overline.

It is expected that in any single application a particular pin will always be programmed to serve the same function.

The flexibility of multiplexing allows a single chip to offer a richer pin selection than would otherwise be possible.

In addition to multiplexing, many pins are also multi-purpose. For example, the EBC peripheral controller address

pins are used as outputs by the PPC405GP to broadcast an address to external slave devices when the

PPC405GP has control of the external bus. When, during the course of normal chip operation, an external master

gains ownership of the external bus, these same pins are used as inputs which are driven by the external master

and received by the EBC in the PPC405GP. In this example, the pins are also bidirectional, serving as both inputs

and outputs.

Intialization Strapping

One group of pins is used as strapped inputs during system reset. These pins function as strapped inputs only

during reset and are used for other functions during normal operation (see “Strapping” on page 55). Note that the

use of these pins for strapping is not considered multiplexing since the strapping function is not programmable.

Pin Summary

Group

No. of Pins

413-Ball package

456-Ball Package

25 mm

35 mm

27mm

PCI

606060

Ethernet

SDRAM

717171

External peripheral

External master

Internal peripheral

Interrupts

JTAG

555

System

Total Signal Pins

300

OVDD

VDD

Gnd

266056

Thermal (and Gnd)

Reserved

Total Pins

413

456

405GP bảng dữ liệu(PDF) 33 Page - Applied Micro Circuits Corporation

405GP bảng dữ liệu(HTML) 33 Page - Applied Micro Circuits Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59

bảng dữ liệu tải về

Link URL