AD7949 datasheet(19/20 Pages) AD

19 / 20 page

Preliminary Technical Data

AD7689

Rev. PrC | Page 19 of 20

APPLICATION HINTS

LAYOUT

The printed circuit board that houses the AD7689 should be

designed so that the analog and digital sections are separated

and confined to certain areas of the board. The pinout of the

AD7689, with all its analog signals on the left side and all its

digital signals on the right side, eases this task.

Avoid running digital lines under the device because these

couple noise onto the die unless a ground plane under the

AD7689 is used as a shield. Fast switching signals, such as CNV

or clocks, should not run near analog signal paths. Crossover of

digital and analog signals should be avoided.

At least one ground plane should be used. It could be common

or split between the digital and analog sections. In the latter

case, the planes should be joined underneath the AD7689s.

The AD7689 voltage reference input REF has a dynamic input

impedance and should be decoupled with minimal parasitic

inductances. This is done by placing the reference decoupling

ceramic capacitor close to, ideally right up against, the REF and

GND pins and connecting them with wide, low impedance traces.

Finally, the power supplies VDD and VIO of the AD7689

should be decoupled with ceramic capacitors, typically 100 nF,

placed close to the AD7689 and connected using short, wide

traces to provide low impedance paths and reduce the effect of

glitches on the power supply lines.

An example of a layout following these rules is shown in

Figure 21 and Figure 22.

EVALUATING AD7689 PERFORMANCE

Other recommended layouts for the AD7689 are outlined

in the documentation of the evaluation board for the AD7689

(EVAL-AD7689CBZ). The evaluation board package includes

a fully assembled and tested evaluation board, documentation,

and software for controlling the board from a PC via the

EVAL-CONTROL BRD3Z.

Figure 21. Example Layout of the AD7689 (Top Layer)

Figure 22. Example Layout of the AD7689 (Bottom Layer)

AD7949 bảng dữ liệu(PDF) 19 Page - Analog Devices