SOF-1917-MI

Rev. 1.1

www.sagemillimeter.com | 3043 Kashiwa Street, Torrance, CA 90505

Phone: 424-757-0168 | Fax: 424-757-0188 | Email: sales@sagemillimeter.com

Page | 3

U-Band Wide Mechanical Tuning Bandwidth Gunn Oscillator, 44 to 56 GHz

Copyright © 2018 by SAGE Millimeter, Inc.

Note:

• All data presented is collected from a sample lot. It is for illustration only. Actual data varies unit

to unit.

• The data given above was tested under case temperature +35 °C.

• Always set the micrometer reading to around 50 GHz when turning on the oscillator to ensure the

correct mode operation.

• SAGE Millimeter Gunn oscillator regulator, model SOR-R3, is highly recommended to prevent the

Gunn oscillator damage due to possible over voltage and/or reverse bias. The outline of the

regulator is shown in the appendix section below.

• SAGE Millimeter, Inc. reserves the right to change the information presented without notice.

Caution:

• Reversing polarity will destroy the device.

• Bias voltage should not exceed +5.2 Volts.

• The case temperature of the device should not exceed +50 ˚C. Use an additional heatsink or fan

if necessary.

• When handling coax connectors, proper torque, 8.0 ± 0.4 inch-pounds (0.90 ± 0.02 Nm), should

be applied. SAGE Millimeter torque wrench, model SCH-08008-S1, is highly recommended.

• Any foreign objects in the waveguide will destroy the device.

Appendix: Outline of Gunn Oscillator Regulator, Model SOR-R3