KG Technologies Inc.

Phone: +1.888.513.1874

Email: info@kgtechnologies.net

Web: www.kgtechnologies.net

K248_EN Rev 2.0

4

Application Notes

1. It is possible that during transit or final assembly the relay could change state. Therefore, it is recommended that

all relays be set to the desired state via a power supply.

2. In order to maintain an “Open” or “Closed” state of the relay, the coil voltage should reach the rated voltage. The

pulse width should be 50ms minimum to ensure a proper change of state. DO NOT energize both T1 and T3 at

the same time on a Dual Coil or energize the coil for longer than 1 minute (damage to the coil could occur).

3. Applying excessive heat to the relay terminals (soldering or welding) can cause damage to the internal structure

of the relay and should be avoided.

4. Moving or bending the terminals can cause damage to the internal structure of the relay and should be avoided.

5. For definitions of terms used in this data sheet, see glossary at www.kgtechnologies.net.

Disclaimer: This datasheet is for reference only. All specifications are subject to change without prior notice.

KG Technologies, Inc. cannot predict every possible application for our relays. While we do our best to make our relays

as versatile as possible, we highly recommend contacting our engineering team if you have any questions.

KG Technologies, Inc. is not responsible for malfunctioning relays when operated outside the specified parameters given

in this datasheet.