PM7366-PI datasheet(266/286 Pages) PMC

266 / 286 page

RELEASED

PM7366 FREEDM-8

DATA SHEET

PMC-1970930

ISSUE 4

FRAME ENGINE AND DATA LINK MANAGER

PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA,INC., AND FOR ITS CUSTOMERS’ INTERNAL USE

253

During clock 6, the target is still not ready so another wait state is added.

During clock 7, the target asserts TRDYB to indicate that it is ready to complete the transfer.

During clock 8, the target latches in the last word and negates TRDYB and DEVSELB, having

seen FRAMEB negated previously. The initiator negates IRDYB. All of the above signals shall be

driven to their inactive state in this clock cycle except for FRAMEB which shall be tri-stated.

Figure 29 – PCI Write Cycle

PCICLK

FRAMEB

AD[31:0]

C/BEB[3:0]

IRDYB

TRDYB

DEVSELB

Address Data 1

Data 2

Data 3

Byte En Byte En

Byte Enable

Bus Cmd

The PCI Target Disconnect (Figure 30) illustrates the case when the target wants to prematurely

terminate the current cycle. Note, when the FREEDM-8 is the target, it never prematurely

terminates the current cycle.

A target can terminate the current cycle by asserting the STOPB signal to the initiator. Whether

data is transferred or not depends on the state of the ready signals at the time that the target

disconnects. If the FREEDM-8 is the initiator and the target terminates the current access, the

FREEDM-8 will retry the access after two PCI bus cycles.

During clock 1, an access is in progress.

During clock 2, the target indicates that it wishes to disconnect by asserting STOPB. Data may be

transferred depending on the state of the ready lines.

During clock 3, the initiator negates FRAMEB to signal the end of the cycle.

During clock 4, the target negates STOPB and DEVSELB in response to the FRAMEB signal

being negated.

PM7366-PI bảng dữ liệu(PDF) 266 Page - PMC-Sierra, Inc