■ Specifications and Test Methods

1

2

3

4

5

6

7

8

9 Adhesive Strength of

Termination

No removal of the terminations or other defect should occur.

Mounting method

Solder the capacitor on the test substrate

Applied Force

5N

Holding Time

10+/-1s

Applied Direction

In parallel with the test substrate and vertical with the capacitor side

Temperature

Characteristics of

Capacitance

No bias

Nominal values of the temperature coefficientis is

The capacitance change should be measured after 5 min at each specified temp. stage.

shown in Rated value. But, the Capacitance Change

Capacitance value as a reference is the value in "*" marked step.

under Reference Temperature is shown inTable A.

Capacitance Drift

The capacitance drift is calculated by dividing the differences between the maximum and minimum

Capacitance Drift: Within +/-0.2% or +/-0.05pF

measured values in the step 1,3 and 5 by the cap. value in step 3.

(Whichever is larger.)

Temperature Step

Q or Dissipation Factor

(D.F.)

Q≧800+20C C:Nominal Capacitance(pF)

Measurement Temperature

Room Temperature

Measurement Frequency 1.0+/-0.1MHz

Measurement Voltage

0.5 to 5.0Vrms

Capacitance

Shown in Rated value.

Measurement Temperature

Room Temperature

Measurement Frequency 1.0+/-0.1MHz

Measurement Voltage

0.5 to 5.0Vrms

Insulation

Resistance(I.R.)

(Room Temperature)

More than 10000MΩ

Measurement Temperature

Room Temperature

Measurement Point

Between the terminations

Measurement Voltage

Rated Voltage

Charging Time

1min

Charge/discharge current

50mA max.

Voltage proof

No defects or abnormalities.

Measurement Point

Between the terminations

Test Voltage

250% of the rated voltage

Applied Time

1s to 5s

Charge/discharge current

50mA max.

Appearance

No defects or abnormalities.

Visual inspection

Dimension

Shown in Dimension.

Using Measuring instrument of dimension.

No

Item

Specification

Test Method(Ref. Standard:JIS C 5101 (all parts), IEC60384 (all parts)）

Rated Voltage

Shown in Rated value.

The rated voltage is defined as the maximum voltage which may be applied continuously to the capacitor.

When AC voltage is superimposed on DC voltage, V(peak to peak) or V(zero to peak),

whichever is larger, should be maintained within the rated voltage range.

GQM1555C2DR10WB01-01A

3