GSC24BC01/02/02/04/08/16

Page: 6/9

ISSUED DATE :2006/06/14

REVISED DATE :

Figure 6. START & STOP DEFINITION

Figure 7. Output ACKNOWLEDGE

Device Addressing

To enable the chip for a read or write operation, an 8-bit device address word followed by a START condition

&In the 1K/2K chip, the next 3 bits should correspond to the hard-wired input A2, A1 and A0 device address

bits.

&In the 4K chip, the next 3 bits are the A2 and A1 device address bits and a memory page address bit. The

two device address bits must compare to their corresponding hard-wired input pins.

&In the 8K chip, the next 3 bits include the A2 device address bits with the next 2 bits used for memory

page addressing. The A2 bit must compare to its corresponding hard-wired input pin.

&In the 16K chip does not use any device address bits but instead the 3 bits are used for memory page

addressing.

Figure 8. Device Address

The memory page address bits, P2, P1 and P0 are used to select the page in the array. P2 represents the

most significant bit, while P1 and P0 are considered the next most significant bits.

The eight bit of the device address determines read or write operation. If the R/W bit is high, then a read

operation is initiated. Otherwise, if the R/W bit is low, then a write operation is started.

After comparing the device address and finding a match, the EEPROM device will issue an acknowledgment

by pulling SDA low. If the comparison fails, the chip will return to standby mode.