MCP3551-ESLASHMS datasheet(20/30 Pages) MICROCHIP

tên linh kiện	MCP3551-E/MS

Giải thích chi tiết về linh kiện	Low-Power, Single-Channel 22-Bit Delta-Sigma ADCs

PDF	30 Pages

Scroll/Zoom	100%

nhà sản xuất	MICROCHIP [Microchip Technology]

Trang chủ	http://www.microchip.com

Logo

20 / 30 page

MCP3550/1/3

DS21950D-page 20

If 24 bits of data are required from this conversion, they

must be accessed during this communication. You can

terminate data transition by bringing CS high, but the

remaining data will be lost and the converter will go into

Shutdown mode. Once the data has been transmitted

by the converter, the SDO/RDY pin will remain in the

LSB state until the 25th falling edge of SCK. At this

point, SDO/RDY is released from the Data Acquisition

mode and changed to the RDY state.

5.4.2

2-WIRE CONTINUOUS

CONVERSION OPERATION,

(CS TIED PERMANENTLY LOW)

It is possible to use only two wires to communicate with

the MCP3550/1/3 devices. In this state, the device is

always in Continuous Conversion mode, with internal

conversions continuously occurring. This mode can be

entered by having CS low during power-up or changing

it to a low position after power-up. If CS is low at power-

up, the first conversion of the converter is initiated

approximately 300 µs after the power supply has

stabilized.

Note:

The RDY state is not latched to CS in this

mode; the RDY flag dynamically updates

on the SDO/RDY pin and remains in this

state until data is clocked out using the

SCK pin.

MCP3551-E/MS bảng dữ liệu(PDF) 20 Page - Microchip Technology